Mike Power 8000mAh Wireless Jump Starter with Built-in Cable
Stay charged up and in control, no matter where life takes you. Designed in collaboration with the renowned Formula Drift driver Mike Power, this 8000mAh Wireless Jump Starter brings unmatched reliability and convenience to your on-the-go power needs.
Forget your phone's charging cable? No worries. A Mfi-certified lighting charging cable is conveniently stored under the top flap of the power bank.
Forget your phone's charging cable? No worries. A Mfi-certified lighting charging cable is conveniently stored under the top flap of the power bank.
Point out charging ports, Qi Charging area, LCD, hazard lights, flashlight, port cover
Point out charging ports, Qi Charging area, LCD, hazard lights, flashlight, port cover
Don’t get stranded on the side of the road with a dead battery. Jump start gas engines up to 6.0L and diesel engines up to 3.0L.
Don’t get stranded on the side of the road with a dead battery. Jump start gas engines up to 6.0L and diesel engines up to 3.0L.
See real-time step-by-step jump-starting instructions and safety notifications on the integrated LCD screen. Multiple languages available.
See real-time step-by-step jump-starting instructions and safety notifications on the integrated LCD screen. Multiple languages available.
FAQ
How do I jump start a 12V vehicle?
1. Check battery percentage on LCD screen. Recommend > 50% battery before attempting a jump-start.
2. Connect the red battery clamp of jumper cable to the vehicle’s positive (+) battery terminal and connect the black battery clamp of jumper cable to the vehicle’s negative (-) battery terminal.
3. Caution! Do not connect the red clamp (+) and the black clamp (-) at the same time.
4. Ensure the battery clamps are connected correctly, and the connectors are free from rust and dirt.
5. Plug the blue cord jumper cable into the jump start socket, and ensure the blue plug is secured.
6. Start the vehicle.
7. Once the vehicle starts, remove the jumper cable from the unit Please reference user manual for full instructions and warnings.
The engine dies shortly after it was jump started or as soon as the jump starter is disconnected.
The vehicle charging system may not be working (bad alternator, voltage regulator, wiring problem or loose/dirty battery cables). Please seek a mechanic for help. The jump start may also not work correctly for vehicles that require remote battery jumper locations (i.e. battery located in the trunk or other location).
How often should I recharge the Jump Starter?
We recommend checking the battery level once every two to three months if you have not been using the device. If the LED indicator lights show three solid lights or less, it's time to recharge the device. Press the power button to check the battery status on the LCD screen. If the LCD screen does not light up, the jump starter needs to be recharged.
How long does it take to recharge the Jump Starter?
The Jump Starter will take approximately 4-5 hours for a full charge.
Can I travel on a plane with this Jump Starter & Power Bank?
As of March 2017, you may take this model with you on flights either in your carry-on luggage or checked bagged as long as the lithium-ion battery is less than 100 watt-hours. Check the U.S. Department of Transportation to see if the regulations have changed to ensure you are in compliance. Online site to check travel regulations for lithium batteries: https://phmsa.dot.gov/safetravel/batteries.
Can I throw the device into my garbage can with my other trash?
No, the device contains lithium batteries and must be properly disposed at a recycling center. If you do not have a local recycling center or need additional information, please call 1-800-822-8837. Note: This 12V Car jump starter and portable power bank contains the equivalent of 2.4g of lithium and gives 29.6 watt hours of power.
What is the peak current?
The peak current is up to 400A. Most small and medium-sized cars and crossovers only require 200-400A.
How much lithium is in the Jump Starter?
This 12V jump starter and portable power bank contains the equivalent of 2.4g of lithium and gives 29.6 watt hours of power.
Can I replace the batteries inside the jump starter?
No, no modifications should be made to the Jump Starter. Removing the lithium batteries yourself may cause a serious injury. Do not attempt to make any modifications to the device.
Is the lightning connector MFI-certified by Apple?
Yes.
How do you use the wireless charger?
Set your phone on top of the jump starter deck, then press the jump starter power button next to the LCD screen.
Can I charge two USB powered devices at the same time?
Yes, both USB ports can be used at the same time.
How do I use the LED flashlight?
Press the power button for 5 seconds or until the LED starts to illuminate. Press the power button again until the correct light mode appears. There are three options: ON, Strobe, or SOS.
Why do the red and green LED lights start blinking when I connect the cables to the Jump Starter?
This is a visual indicator to show your car is ready to be jump started. If the indicator does not turn solid green, this indicates the car battery voltage is higher than the Power Bank. You can still jump start your battery but may need to charge your Power Bank.
What does a solid green light on (red off) mean?
It means the car battery is ready for jump start.
What does a solid red light (green light is off) mean?
The Power Bank needs to be charged.
What does a blinking red light (green off) with a beeping noise mean?
Disconnect the jumper cable from the car battery and Power Bank. The car jump is either complete or there is a connection issue.
What does a solid red and solid green light mean?
Disconnect the jumper cable from the car battery and Power Bank to reset. This status shows up after 30 seconds indicating the jump start process has timed out.
What does it mean when neither LED (red or green) light up?
That is very unusual. Please contact Winplus for troubleshooting.
Which battery terminal do I connect the red clamp to?
The red clamp is for the positive terminal.
Which battery terminal do I connect the black clamp to?
Connect the black clamp to the negative terminal.
Why do I need to drive the car for 30 minutes after jump starting?
Driving 20-30 minutes after jump starting helps charge the car battery further or you may need another jump start.
How do I know if my car is 12V?
Check with your car manufacturer. Most cars batteries are 12V unless it is a diesel fueled car. If it is a 24V car, do not use this jump start.
Product specification
Length: 6.14 in / 155 mm
Width: 3.5 in / 88 mm
Height:1.34 in / 34 mm
0.97 lb / 439 g
Lithium-Ion
29.6 Wh
5V 2A
5V 3A / 9V 2A
5V 3A / 9V 2A
5V 3A
400A
-20ºC ~ 34ºC / -4ºF ~ 93ºF
-20ºC ~ 40ºC / -4ºF ~ 104ºF Avg. Temp.
0ºC ~ 34ºC / 32ºF ~ 93ºF
4-5 hours (5V 2A input)
2-2.5 hours (18W USB-C input) 18W charger not included
IP64 Splash-Resistant (with Ports Covered)
AC533654-1 (UPC 840005336540)
AC533655-1 (UPC 840005336557)
In the Box
- 1 x Jump Starter Power Bank
- 1 x 12V USB Charger & Micro USB Charging Cable
- 1 x Safe & Smart Jumper Cables
- 1 x Storage Case